Mold remediation referrals for Nashville & nearby townsCall: (615) 813-4805
(615) 813-4805

HVAC & Air Duct Mold Removal in Thompson's Station, TN

moldremediationnashvilletn.net

Sort out which parts of a moldy HVAC system you can handle and which belong to a remediation company.

Mold showing up around the AC in your Thompson's Station home?
Call now to be connected with a local mold remediation company in Thompson's Station.
(615) 813-4805

Thompson's Station is a Williamson County town between Franklin and Spring Hill, about 26 miles from Nashville. Mold in an HVAC system here usually grows where condensation collects, on the coil, in the drain pan or on ducts in the attic or crawl space, and removing it means cleaning or replacing those parts and fixing the moisture. Call the number on this page to be connected with a local mold remediation company in Thompson's Station.

Ductwork in a crawl space being inspected, hvac & air duct mold removal in Thompson's Station, TN

What homes in Thompson's Station deal with

Thompson's Station grew from railroad-era roots, saw a Civil War battle in 1863 and incorporated as a town in 1990. Wherever the air handler sits in your house, attic, crawl space or closet, it faces the same climate. Summers here are long and humid, so the coil wrings water out of the air almost every day from May to September. That water has to drain. Ducts in unconditioned spaces also have to stay insulated and sealed, or they sweat. When the May 2010 flood dropped about 14.4 inches of rain on the town over two days, crawl spaces near creeks were the ones most exposed. Williamson County still warns that flash floods can come with little warning and that blocked culverts and ditches can flood property too, so check under the house after any heavy storm.

What you can do vs what needs a pro

TaskHomeownerRemediation company
Turn the system offYes, right away
Change the filter, wipe a register coverYes, for small spots
Flush the condensate lineOften, following the unit's manualOr the HVAC contractor
Clean the coil, blower or cabinet interiorYes
Remove moldy lined or flex ductYes, with containment
Fix crawl space humidity or attic duct sealingYes, or with an HVAC contractor

EPA says a homeowner can usually handle a moldy area under about 10 square feet. Growth inside the equipment or ducts is a different matter, because the blower can spread it.

Call now to be connected with a local mold remediation company in Thompson's Station.
(615) 813-4805
Technician inspecting a furnace and air handler in a basement, hvac & air duct mold removal in Thompson's Station, TN

Signs to look for

  • A musty smell that follows the blower.
  • Water around the air handler or a stain on the ceiling below it.
  • Growth on supply registers or the return grille.
  • Damp duct wrap or condensation on metal duct.

Seasonal timing

Book drain and coil maintenance in spring, before the cooling load ramps up. Check the attic in July and August, when duct sweating is worst. Jobs of $25,000 or more need a Tennessee contractor's license, and mold remediation is the S-F classification. If ductwork or equipment is replaced, building permit applications go to the Town of Thompson's Station, where Planning and Codes review them together. The Williamson County Health Department in Franklin can help with health questions.

HVAC & Air Duct Mold Removal questions in Thompson's Station

What indoor humidity keeps mold out of the system?
EPA suggests keeping indoor humidity below 60 percent, ideally between 30 and 50 percent. A simple hygrometer shows where you stand, and an AC that is sized and maintained properly does much of the drying in summer.
Can mold grow on the coil or inside the air handler?
Yes. The coil is wet whenever the AC runs, and dust on it gives mold something to feed on. Cleaning the coil, blower and pan is often part of the job, and the written scope should list which parts get cleaned and which get replaced.
Will duct cleaning alone fix the problem?
No. EPA warns that mold in a duct system will likely return if the moisture that caused it is not corrected, whether that is a clogged drain, sweating ducts or a damp crawl space.
What should I check before hiring a company for duct mold work in Tennessee?
Jobs of $25,000 or more need a Tennessee contractor's license with the right classification, and mold remediation is the S-F classification. Check the company on TDCI's Verify a License search and get a written scope that separates cleaning, replacement and the moisture repair.

More mold services in Thompson's Station

HVAC & Air Duct Mold Removal nearby

Call now to be connected with a local mold remediation company in Thompson's Station.
(615) 813-4805

Last updated:

☎ Call (615) 813-4805